Technical

Butt welding pipe fittings manufactured in conformance with European Standards can be further classified as EN 10253-1, EN 10253-2, EN 10253-3 and EN 10253-4, respectively. EN 10253-1 is the standard specification for butt welding pipe fittings of wrought carbon steel …

1. Technical Drawings According to ISO 4762/ DIN 912 We can supply titanium hexagon socket cap screws manufactured to DIN 912 or its equivalent ISO 4762. The material covers titanium grade 1, grade 2, grade 3, grade 5, grade 7, …

1. Technical Drawings 2. Dimensions of MSS SP 43 Reducers *All dimensions are in inch unit. *H: length of the reducer(concentric or eccentric). *O.Dle: outside diameter at bevel of large end; O.Dse: outside diameter at bevel of small end. 3. …

1. Technical Drawing 2. Dimensions MSS SP 43 180° Returns *All dimensions are in inch unit. Dimension A is equal to 1/2 the O dimension. *Alignment of “U” ends: NPS 8 and smaller: ± 0.03 inch; NPS 10 and larger: …

1. Technical Drawing Note: The MSS SP 43 stub end is short pattern. It can be used with lap joint flanges or slip on flanges, depending on which the radius of fillet may differ. 2. Dimensions of MSS SP 43 …

1. Technical Drawing 2. Dimensions of MSS Sp 43 Reducing Tee *All dimensions are in inch unit. *O.DR: outside diameter of runlet; *O.DO: outside diameter of outlet. *C: length of center-to-end run; M: length of center-to-end outlet. Size range: from NPS …

1. Drawing of Straight Tees 2. Dimensions *All dimensions are in inch unit. *C: center to end run length; *M: center to end outlet length. 3. Tolerances *CM-Tol: the tolerances for center-to-end dimensions C & M; *OA: off angle of …

1. Technical Drawing 2. Dimensions *All dimensions are in inch unit. 3. Tolerances *The CTE-Tol refers to tolerances for center-to-end dimension A & B for 90° & 45° elbows. *OA & OP: tolerances for off angle as shown in above …

MSS SP 43 butt welding fittings are wrought or fabricated for low pressure, corrosion resistant applications. The fittings include 90° & 45° long radius elbows, straight and reducing tees, lap joint stub ends, caps, 180° long radius returns, concentric and …

The DIN/ ISO titanium hexagon head bolts and screws are generally used with its mating hexagon nuts manufactured in accordance with DIN 934 or ISO 4032. The nut material can be either titanium Gr.1, Gr.2, Gr,3, Gr.5, Gr.7, Gr.12, etc. There …

1. General Introduction The same as titanium hexagon bolt, titanium hexagon head screws can also be provided in titanium grade 1 (UNS N50250), grade 2 (UNS N50400), grade 5 (R56400) and grade 7 (R52400). They shall be manufactured according to ISO 4017 …

1. General Introduction We carry a large range of titanium hexagon head bolts in stock. They are manufactured to ISO 4014 and its equivalent standard DIN 931. Generally, the material covers titanium grade 1 (UNS N50250), grade 2 (UNS N50400), …